The MC100FX-SC30-A equips with one 100FX fiber port and one 10/100TX copper port for speed and media conversion. Featuring with SC type connector, the 100FX fiber port can extend network span for up to 30km.

The built-in SC type connector and single-mode fiber transceiver module are capable of extending network span for up to 30km.

 

 

The MC100FX-SC30-A media converter can identify and retain 802.1Q VLAN packets to ensure that Virtual LANs (VLANs) operation across the media converter.

 

 

With Auto-negotiation, the 10/100TX copper port can synchronize transmission speed and mode with peer devices. In addition, Auto-crossover on 10/100TX copper port eliminates circuit mismatch problem by auto-sensing the MDI/MDIX function; both features make installation easier to complete. Meanwhile, multiple configurations can be done via DIP switches to give users more management capability for better control over the devices.

 

 

With the Link Fault Signaling (LFS) mechanism, one failed link detected on the 10/100 copper port will force to stop a link on the fiber port, and vice versa. The copper downlink port will stop transmitting and turned off as soon as the remote link is failed, and the Spanning Tree Protocol (STP) of the connected switch will start functioning as a result to activate the backup link that secure the network operation. Transparent link status is delivered by LFS mechanism to make network recovery and troubleshooting easier and faster.

Standard Compliance

• IEEE802.3 10BASE-T
• IEEE802.3u 100BASE-TX/FX
• IEEE802.3x Flow Control and Back pressure

Transparent Packet

• 64 to 1518 Bytes for Non-VLAN Ethernet packet
• 68 to 1522 Bytes for VLAN-Tag type Ethernet packet

Link Fault Signaling (LFS)

• TX to Fiber: If TX port link down, then converter will forced fiber to link down.
• Fiber to TX: If Fiber port link down, the media converter will forced TX port to link down.

Hardware Specification

• Support auto-negotiation on 10/100TX copper port
• Support auto MDI/MDI-X on 10/100TX copper port
• DIP Switch
  • DIP 1 - Enables / disables auto-negotiation
  • DIP 2 -Copper port (RJ45) duplex mode; full-duplex or half-duplex
  • DIP 3 -Copper port (RJ45) data bit rate; 10Mbps or 100Mbps
  • DIP 4 - Fiber port duplex mode; full-duplex or half-duplex
  • DIP 5 - Enables / disables link fault signaling (LFS)
  • DIP 6 - Enables / disables local loop back (LLBK)
  • DIP 7 - Enables / disables remote loop back (RLBK)
• One 10/100BASE-T ports and one 100BASE-FX Fiber Port (SC) with single-mode fiber transceiver module built-in
• Enabling Maximum transmission distance: 30km
• Wavelength of 100FX fiber: 1310nm

Physical Specifications

• Dimension: 73.8(W) x 109.2(H) x 23.4(D)mm
• Weight: 160g

Power Requirements

• External power adapter; 12V DC/ 0.8A
• Max power rating: 2.4 Watt

Environmental Specifications

• Operating temperature: 0°C ~ 45°C
• Storage temperature: -20°C ~ 80°C
• Operating humidity: 10% ~ 90%, non-condensing

Certification

• Safety: CE LVD
• EMC: FCC Part15 (Class A), CE EMC (Class A)